Been a little while between drinks as my family and I have been sick over the last few weeks so progress has been limited.
[singlepic id=476 w=740 h=555 float=center]
Not to mention there has been a bit of “multi-itis” going on as well (doing things more than once, I hate that!).
[singlepic id=470 w=740 h=555 float=center]
[singlepic id=471 w=740 h=555 float=center]
We also ran into a few issues with the bending software including tubes that weren’t selected in the cuts. Fitting up we were wondering why there was a notch where there was not meant to be a tube notched, took us a little while to figure that one out.
[singlepic id=474 w=740 h=555 float=center]
[singlepic id=475 w=740 h=555 float=center]
Two more tubes to bend up and the greater suspension in the back is done, only bracing to go.
[singlepic id=477 w=740 h=555 float=center]
It’s finally starting to look like a real chassis!
Tone